I finally found some time to make this piece I have been thinking about!
I managed to take some photos during the process. I hope this tutorial inspires you to make one of your own.
Cut out the patterns on mat board. I used a very sharp craft blade.
NOTE: When cutting out the clock face backing and cupboard door frame, use cereal box cardboard.
Gently sand the edges if necessary for the two side pieces. I used a foam-centered nail file.
Using yellow wood glue, run glue along the edges of the back piece and brace it between the two side pieces with a toothpick. I used two small square boxes with some weight to them to help brace everything while it dried.
Put glue on the back and side edges of the 5 shelf pieces and slide them into the appropriate slots.
Put glue on the top edges of the shelf and glue on the top piece. The back of the top should be flush to the back of the shelf. Brace the top against another box.
Glue the base front on and then both side bases. Gently stand it up to be sure its even when the glue just starts to set. When you are happy turn it over and coat some wood glue on the inside corners.
Score the corners on the cupboard door frame with the back of your blade and glue the thin cardboard molding onto the cupboard door.
Glue in cupboard insets.
Glue in clock face insets. The door will rest on these, one above and below.
Glue the clock face onto the thin-board clock face backing.
Glue the cap on top and once set, glue the two tops onto that.
Once glue is dry, paint entire piece and the clock face door frame (do not assemble this piece yet). Sand and apply paint until you are happy.
Drill holes for knobs on cupboard and clock face door.
Glue the clock face door on. Put glue on front edge of top shelf and the top edge of clock face door. Set in, careful the door does not fall into the clock at the top. Add acetate to back of door if you want glass there.
Put a dab of Tacky Glue on the curve of the cap, let it dry just a bit and then place bead on the glue. Glue seed bead on top of bead. Let dry and then paint.
Please keep in mind there may be piece you have to test fit first and trim a bit. It will depend on how you place your pieces together. Things may be off just a hair.